PSC PT Program Generator Manual de usuario descargar pdf (Pagina 26)

26 of 30

The File Transfer Utility will appear, waiting to receive data from sender (PT40).

Sending Files from PT40 to the Computer.

You should already have XFER32 waiting to receive data as illustrated above.

Since you are trying to send data from the PT40 to the PC it is assumed that have already

gathered some data onto the PT40.

i-PO Receive includes two different programs that are loaded onto your PT40.

>F3 Serials Only (gathers serial numbers only)

>F4 Item, Qty (gathers Item or UPC Codes and Quantities)

Only “F4 Item, Qty” is used for iPO Receive. The other program is for future expansion.

Each program has its own data file on the PT 400. Select F4 to enter the program that has data

you wish to transmit. Select F2 to upload the data to the computer. Place the PT40 on the dock

and F2 again to begin the file transfer process.

When the upload is complete the PT40 will display *UPLOAD DONE*

If the upload fails the display will read *UPLOAD FAILED*. The reason for the failure is

clearly stated in the status window. If the upload fails make sure that XFER32 is running and

its Status is “Waiting for Sender”. If that was so, then use XFER32 SETUP to change the COM

port to the correct port. See XFER32 Setup above.

1 2 ... 21 22 23 24 25 26 27 28 29 30

Sin comentarios

PSC PT Program Generator Manual de usuario Pagina 26