PSC Magellan 1400i Manual de instrucciones Pagina 67
- Pagina / 180
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Global Pre-
fix/Suffix
Product Reference Guide
4-3
Global Prefix/Suffix — cont.
START / END
PROGRAMMING BARCODES
Sets up to 20 characters each from the set of ASCII characters or any hex value from 0 to FF. To configure this feature, scan the
“START/END” bar code above to place the unit in Programming Mode, then the “Set Prefix” or “Set Suffix,” followed by the digits from
the Alphanumeric table in
Appendix C, Alpha-Numeric Pad representing your desired character(s). Reference the section,
"Example: Setting a Prefix", for more information. Exit programming mode by scanning the “START/END” barcode again (scan
“START/END” twice if less than 20 characters have been selected).
DEFAULT SETTING PREFIX: 00 (None)
DEFAULT SETTING SUFFIX: 0D (CR)
Set Prefix
Set Suffix
- Magellan 1
- Table of Contents 3
- Product Reference Guide 5
- Getting Started 7
- Connecting the Scanner 8
- Programming 9
- LED and Beeper Indicators 10
- Error Codes 11
- 1-6 Magellan 12
- General Features 13
- Double Read Timeout — cont 14
- PDF Double Read Timeout 14
- PDF Double 15
- Read Timeout 15
- Label Gone Timeout 16
- PDF Label Gone Timeout 16
- Sleep Mode 17
- Sleep Mode — cont 18
- Good Read: When to Indicate 20
- ³ 001402 21
- Good Read Beep Length 22
- Good Read Beep Volume 23
- Scanning Features 24
- Target Mode: Active Time 25
- Target Mode: Linger Time 26
- ³ 03B819 27
- Wake Up Intensity — cont 28
- Interface Related Features 29
- Interface Selection 31
- Interface Selection — cont 32
- Obey/Ignore Host Commands 35
- Host Transmission Buffers 36
- RS-232 Interface Features 37
- Hardware Flow Control 39
- Intercharacter Delay 40
- Software Flow Control 41
- Host Echo 42
- Host Echo Quiet Interval 43
- Signal Voltage: Normal/TTL 44
- RS-232 Invert 45
- Beep on ASCII BEL 45
- Beep on Not on File 46
- ACK NAK Options 47
- ACK Character 48
- NAK Character 48
- Retry on ACK NAK Timeout 49
- ACK NAK Timeout Value 49
- ACK NAK Retry Count 50
- ACK NAK Error Handling 51
- IBM-USB Device usage 52
- Interface 53
- Features 53
- Supported Symbologies 54
- Bar/Space Polarity 55
- Wand Idle State 55
- Signal Speed 56
- Transmit Trailing Noise 56
- Transmit Leading Noise 57
- Symbology Conversion 57
- USB Keyboard 58
- Keyboard Wedge — cont 59
- Caps Lock State 60
- ³ 028901 61
- Data Editing 65
- 00 - 20 Characters (ASCII) 66
- Global Prefix/Suffix — cont 67
- Label ID 69
- Label ID — cont 70
- Case Conversion 75
- Character Conversion 76
- UPC-A — continued 78
- Disable/Enable UPC-E 81
- Check Digit Transmission 81
- UPC-E — continued 82
- Expand UPC/EAN to GTIN 84
- Disable/Enable EAN-13 85
- EAN-13 — continued 86
- Disable/Enable EAN-8 88
- EAN-8 — continued 89
- Contact Customer Support for 90
- Two-Label Pairs 90
- Add-ons — continued 92
- Disable/Enable RSS-14 93
- RSS-14 UCC/EAN 128 Emulation 93
- RSS-14 — continued 94
- RSS Expanded 96
- RSS Expanded — continued 100
- RSS Limited 100
- RSS Limited — continued 101
- Disable/Enable Code 39 103
- Check Character Calculation 103
- Code 39 — continued 104
- Pharmacode 39 109
- Pharmacode 39 — continued 110
- Code 128 and UCC/EAN 128 111
- Transmit Function Characters 112
- Length Control 113
- Symbologies 114
- Code 128 Stitching 115
- Minimum Reads 115
- Interleaved 2 of 5 116
- Check Digit Transmit 117
- Interleaved 2 of 5 Stitching 120
- Disable/Enable Codabar 122
- Check Character Verification 122
- Codabar — continued 123
- Quiet Zones 125
- Disable/Enable Code 93 129
- Code 93 — continued 130
- MSI/Plessey 133
- MSI/Plessey — continued 134
- Standard 2 of 5 139
- Standard 2 of 5 — continued 140
- Disable/Enable PDF417 145
- PDF417 Minimum Reads 145
- PDF417 — continued 146
- Micro PDF417 148
- Micro PDF417 — continued 149
- Chapter A 153
- Product Specifications 153
- Physical Properties 154
- Electrical Parameters 154
- Environmental Parameters 154
- Other Parameters 154
- Cable Pinouts 155
- USB & USB Keyboard 156
- Wand Emulation 156
- Keyboard Wedge 156
- Alpha-Numeric Pad 157
- Default Settings 159
- Standard 161
- Feature Defaults 161
- Keyboard Function Key 169
- Mappings 169
- Keyboard 171
- Model Cross Reference 171
- Host Commands 175
- F-2 Magellan 176
- Sample Symbols 177
- ASCII Chart 179
Relacionado con productos y manuales para Lectores De Códigos De Barras PSC Magellan 1400i
Lectores De Códigos De Barras PSC DUET Especificaciones
(400 paginas)
(400 paginas)
(48 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.024 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales