PSC SP400rf Manual de usuario descargar pdf (Pagina 37)

R44-1027 31

LABEL TRANSMIT

FORMAT CONFIG

SETTING A SINGLE CHARACTER PREFIX OR SUFFIX

To set one ASCII character as a prefix or suffix, follow steps one through

four on the previous two pages (select prefix or suffix), then...

1. Scan the two digit Hex Code for that character.

(e.g. 03, 8F, ...FF)

NOTE

If you make a mistake, or lose your place while setting this option,

scan the “end” label to exit Programming Mode. The scanner will

sound a rejection tone (a “good beep” followed by a low “bad

beep”) to indicate that programming was incomplete, and the

setting will remain as it was before entering Programming Mode.

2. Scan the One Character Only label on the following page.

3. Scan the END label.

You have set a single character prefix or suffix.

SETTING PREFIX AND/OR SUFFIX CHARACTERS

NOTE

You must scan the SET label and either the

Set Prefix or Set Suffix label before using the

labels on this page.

0 -----------------------------

1 -----------------------------

2 -----------------------------

3 -----------------------------

4 -----------------------------

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 111 112

Sin comentarios

PSC SP400rf Manual de usuario Pagina 37