
Attaching the Falcon Dock to the Computer
User’s Guide
59
Attaching the Falcon Dock to the Computer
Complete the following steps:
1. Attach the 25-pin end of the cable to the cable connector on the
back of the Falcon Dock (refer to
Figure 24).
2. Attach the other end of the cable to a serial port on the selected
computer.
3. If the optional power adapter was ordered, attach it to the Falcon
Dock (see the next section).
Figure 24: Back Panel of the Falcon Dock
The Power Adapter
A 9-volt power adapter can be used with the Falcon Dock to recharge the
NiCD or NiMH batteries in the Falcon. Power adapters are available from
a PSC dealer or reseller.
Cable connectorPower input jack
NOTE
Use only PSC power supplies approved for the Falcon DOS Portable Data
Terminal
CAUTION
If alkaline batteries are being used in the Falcon, do not connect a power
adapter to the dock. Attempting to recharge alkaline batteries may cause
battery leakage. Use only a 9-volt power adapter supplied by a PSC dealer.
Using another adapter can damage the dock.
2314.book Page 59 Friday, July 12, 2002 1:42 PM
Comentarios a estos manuales